[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] dead usrp board

From: Matt Ettus
Subject: Re: [Discuss-gnuradio] dead usrp board
Date: Tue, 30 May 2006 09:52:26 -0700

On Mon, 2006-05-29 at 19:04 -0400, Bob Vincent wrote:
> I have a usrp board that doesn't respond in any way. I think (in the best 
> case) that the flash might have gotten erased.
> I must admit that I haven't checked the fuse yet. My meter is at home and 
> the board is at work. Assuming that the fuse isn't blown, is there any 
> other diagnostic work I can do before sending it back?

There is no flash onboard, just a small serial eeprom.  Is the LED

The most common problem is blown fuses.  A number of people have
reported them.  I personally have only had one blown fuse in the entire
3 years I've been doing this, and that was when I plugged in a
daughterboard with power on.

The only other thing I've seen is that your computer getting hit by
lightning will kill the USB interface on the FX2 chip, but it will still
flash the LEDs.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]