[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Suse10.1 walkthrough and a question concerning cr
Re: [Discuss-gnuradio] Suse10.1 walkthrough and a question concerning crosstalk
Fri, 22 Sep 2006 15:37:23 -0700
On Fri, Sep 22, 2006 at 05:38:54PM -0400, Mark Sullivan wrote:
> When I inject a signal at a -45 dBm level on the "RX-B" sma connector on a
> Basic RX daughtercard, I see a copy of the signal on the "RX-A" side when I
> use usrp_fft.py. The level is 10-20 dB below that of what I see if I move
> the signal from "RX-B" to "RX-A," but this seems like too much coupling.
> Using a 50 ohm termination on the unconnected sma connector helps a little
> bit. I see no copy of the signal from either input of the other Basic RX
> daughtercard. Any thoghts, anyone?
> Best regards,
> Mark Sullivan
There's a chance that the code that determines the rx digital mux
setting isn't handling this case properly.
Assuming that the Basic Rx is on the "A" side, please try this:
$ usrp_fft.py -R a:0 -f <freq>
and try moving the test signal from RX-A to RX-B
$ usrp-fft.py -R a:1 -f <freq>
and move the test signal from RX-A to RX-B