[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Usrp Board Test Help

From: Michael Dickens
Subject: Re: [Discuss-gnuradio] Usrp Board Test Help
Date: Sat, 5 May 2007 14:14:31 -0400

Melody - If you're running those examples (usrp_fft.py etc), and the window pops up showing noise, and displays similar text to what you wrote, then, yes, your USRP is communicating with GNU Radio successfully and those displays are probably about what one would expect to see (depends on which USRP daughtercards you're using). You -might- see in the background an occasional "uO" or "uU", but those should not be a constant stream; if streaming, then something is wrong. Otherwise, you're good to go on whatever you're trying to do. Good luck !) - MLD

On May 4, 2007, at 6:04 PM, Melody S wrote:
how should I understand that USRP works while I am testing it through gnuradio-examples? because I run the

./usrp_fft.py and ./usrp_oscope.py a window pops up with this information

center frequency=45G
Analog BB=0
DDC= -8M

and shows some noises.

Is that what I suppose to get when I run these commands or I need to get some other information as well?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]