[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] multi_file usrp tuning options
From: |
Eric Blossom |
Subject: |
Re: [Discuss-gnuradio] multi_file usrp tuning options |
Date: |
Thu, 31 May 2007 21:37:12 -0700 |
User-agent: |
Mutt/1.5.9i |
On Thu, May 31, 2007 at 04:11:47PM -0400, address@hidden wrote:
> Hi-
>
> I'm developing a 4-channel receiver using 4 rx paths and 2 LFRX
> daughter boards. I'm basing my code on the multi_* examples in the
> multi-antenna directory. Two of the channels I want to capture are
> AM-modulated at roughly 2 MHz carrier frequency, the other two signals
> are not modulated and are low frequency on the order of 1 kHz.
>
> My question is, can I tune each subdevice to a different frequency? I
> would need to in order to capture both sets of signals simultaneously
> in a phase-locked fashion (this is important).
Yes. See multi-antenna/multi_file.py. It tunes all 4 subdevs.
It happens to tune them all to the same freq, but that's just because
that was what was needed at the time the code was written.
Eric
- Re: [Discuss-gnuradio] multi_file usrp tuning options,
Eric Blossom <=