On Mon, Oct 22, 2007 at 05:13:33PM -0400, Jared Jensen wrote:
What are the proper mux settings for one DBSRX in RXA and one DBSRX
in RXB? When I used a single DBSRX in RXA 0x00000010 worked well.
But now I want Channel 0 to be RXA, and Channel 1 to be RXB both of
which are I and Q, and not swapped.
So far anything other than 0x32103210 or 0x00000010 produces dirty
output with random-looking noise in the data.
Jared
If you're using a single channel, usrp.determine_rx_mux_value will get you
the right answer, regardless of the type of daughterboard.
On the DBSRX, 0x00003210 (or for that matter 0x32103210) will set you
up with side A routed to channel 0 and side B routed to channel 1.
See http://gnuradio.org/trac/wiki/UsrpRfxDiagrams
and http://gnuradio.org/doc/doxygen/classusrp__standard__rx.html
Eric
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.488 / Virus Database: 269.15.3/1081 - Release Date:
10/19/2007 5:41 PM