[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Discuss-gnuradio] USRP2 GigE MAC module - 10Mbps?

From: Jennifer Ann Petersen
Subject: [Discuss-gnuradio] USRP2 GigE MAC module - 10Mbps?
Date: Fri, 25 Apr 2008 17:27:23 -0400

Hi there,

I'd like to use the GigE MAC module for the USRP2 on a piece of (non-USRP2) hardware, but due to project constraints am not able to use GigE or 100Mbps. Does the module support 10Mbps? From the comments in the change logs, I'm guessing not, but just wanted to make sure. From an earlier post on this discussion board it looked like the USRP2 itself might be able to handle 100Mbps or 10Mbps, so I was curious about the implications for the MAC module...

If by some chance it does support 10Mbps, would the signal labeled ".Clk_125M" still need to be a 125Mhz clock? Does ".Clk_user" need to be a 100Mhz clock, as in the demo code?

Thanks much!

reply via email to

[Prev in Thread] Current Thread [Next in Thread]