Re: [Discuss-gnuradio] usrp_wfm_rcv.py

[Muhammad Abrar]

ok thanks
When I run usrp_nbfm_rcv.py from /usr/local/share/gnuradio/

examples/usrp I
the following message appear on GUI
" Failed to set initial Frequency"
How can i frequency set to listen FM.
Take care

2009/1/23 Eric Blossom <address@hidden>

On Fri, Jan 23, 2009 at 12:25:25PM +1300, Muhammad Abrar wrote:
> Hi
> When I run usrp_wfm_rcv.py from /usr/local/share/gnuradio/examples/usrp I
> got following message.
>
>
> Using RX d'board A: Flex 1800 Rx MIMO B
> >>> gr_fir_ccf: using SSE
> >>> gr_fir_fff: using SSE
> FYI: No Powermate or Contour Knob found
>

This is normal.

Do you really have wideband (broadcast) FM up at 1.8GHz?
Around here it's in 87MHz to 107MHz.

Eric

-- 
Engr. Muhammad Abrar
Massey University Palmerston North
NewZealand
Mob: 0064211204202
Res: 006463586340