Re: [Discuss-gnuradio] Exploring the world of GNU

[Bari Bari]

ya I am using SI suffix for Mega Hz.
But still not listening FM. no error appear except failed to set initial frequency.
I have USRP with DBSRX  daughter, and I have two SMA  connector RF1 and RF2, actually this is already installed here and it has no LED on it.as these board supports 800MHz to 2.4 GHz.
So is it possible to operate it on below 800 MHz like FM.
Second I run usrp_oscope.py and usrp_siggen.py but it works only in the range 1.5GHz to 2.0 GHz.
Can u explain the reasons.
Thanks.

2009/1/30 Eric Blossom <address@hidden>

On Wed, Jan 28, 2009 at 10:28:36PM -0800, Karthik wrote:
> Try the following:

> usrp_wfm_rcv.py -f 104.5 -O plughw:0,0

Be sure to provide the SI suffix on the freq otherwise it's going to
try to tune to 104.5 Hz

 usrp_wfm_rcv.py -f 104.5M -O plughw:0,0

Eric