[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] EEPROM warning

From: Woody Dickson
Subject: Re: [Discuss-gnuradio] EEPROM warning
Date: Tue, 17 Feb 2009 11:21:54 +0800

I have one USRP board and 2 Flex900 boards.  The Flex900 board has
both RX2 and TX/RX.  I installed and screwed both Flex900 boards on
USRP motherboard and make sure all the holds are matched.

On the B side, I have Flex900 card.

What do you think could be the problem?


On Tue, Feb 17, 2009 at 1:56 AM, Matt Ettus <address@hidden> wrote:
> Woody Dickson wrote:
>> Hello,
>> Any know what is the cause of the following EEPROM warning?  I would
>> appreciate any suggestion on how to resolve this problem.
>> address@hidden usr]# usrp_siggen.py -f1
>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>> were a "Basic Tx."
>> Warning: This is almost certainly wrong...  Use appropriate
>> burn-*-eeprom utility.
>> Using TX d'board A: Flex 900 Tx MIMO B
>> Failed to set RF frequency
> What do you have on the B side?
> Matt

reply via email to

[Prev in Thread] Current Thread [Next in Thread]