Re: [Discuss-gnuradio] Question about loop testing usrp

[Eric Blossom]

On Wed, Mar 18, 2009 at 11:39:00AM +0800, Pete Kay wrote:
> Hi,
> 
> I am trying to run siggen-oscope test using the "A" board for the
> siggen and the "B" board for the oscope.
> 
> I use the command usrp_oscope.py --rx-subdev=A to specify the board
> side, but this does not work.  Could someone please help me to correct
> my command?
> 
> The other problem I have is that if I have a physical signal
> generator, and I wire up this signal generator to RX of A, and then
> the signal analyzer to the TX/RX of B.  How can I run this loop thise?
>  What python file can I run?
> 
> Thanks alot for your help.
> 
> Pete

Pete,

You're not giving us much to work with here.

Can you please take a look at this page, then try again?

  http://gnuradio.org/trac/wiki/ReportingErrors

Eric