[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Command Line Arguments for usrp transmission and

From: Johnathan Corgan
Subject: Re: [Discuss-gnuradio] Command Line Arguments for usrp transmission and reception
Date: Tue, 24 Mar 2009 10:49:35 -0700

On Tue, 2009-03-24 at 13:34 -0400, Ahmed Majeed Khan wrote:

> >> $ python ./benchmark_rx.py -f 10M -R A --rx-gain=70 -v -r 500K
> >> bitrate:         250kb/s
> >
> >> $ python ./benchmark_tx.py -TA -f 10M -r 500k -v
> --tx-amplitude=20000
> >> bitrate:         500kb/s
> >
> Bitrate while using above command line arguments is 500kb/s at both,
> transmitter and receiver. 

Um, the lines quoted above are from your own output, clearly showing
they are different.  Also, the correct form for specifying the bitrate
is to use lower case 'k'; the above will actually give you an error.

> Changing transmitter to -r 250k makes transmitter rate 250kb/s,
> apparently creates a mismatch between transmitter and receiver. 

What are you talking about?

> However, in either case, receiver console displays nothing for any
> packet reception.

You are using two different USRPs, and they are connected by some sort
of cable, correct?


reply via email to

[Prev in Thread] Current Thread [Next in Thread]