Re: [Discuss-gnuradio] parallel data reception

[Jason Uher]

> usrp_dual_source want antennas which should be used as input parameters, as
> follows (I copied this line from a question posted on a thread which was
> using LFRX daughter cards)
>
> self.usrp_dual_source_x_0 = grc_usrp.dual_source_c(which=0, side_a='A',
> rx_ant_a='RXA', side_b='A', rx_ant_b='RXB')
>

This is correct (assuming you are using GRC)  The side A and side B
refer to the side of your usrp, not the ports on the RFX board itself.
 Since you can have two daughter boards, the are side A ad B
respectively, you will have to use the rfx antenna select function to
choose between TX/RX and RX2.

If you are not using grc I have attached a file that I use to capture
data from two RFX2400 boards in the same usrp, it will probably
require some modifications for your application, but its a start.

Jason

multi_rfx_2400.py
Description: Binary data