|
From: | Judah, Charles C CIV USAF AFMC 775 TS/ENV |
Subject: | [Discuss-gnuradio] Data from File on command. |
Date: | Fri, 24 Jul 2009 15:37:16 -0700 |
The current implementation: I am trying to send various commands to a UAV. The system
uses a file source, packet encoder, dpsk modulator, throttle, multiply by
constant, and USRP sink using RFX400 daughter boards. The flow graph
(connections) happen in the order stated. If the flow graph is already running using Auto T/R so that
when I finish sending a single command packet the USRP stops transmitting a
carrier, how do I send more data over the same flow graph without restarting
it? I have been searching for 3 days in an attempt to find a functional
solution for this. Basically what I need to happen is: A.
Either I edit the file used in the file source
and then “jump start” the flow graph to re-read the file source and
repeat the operational data path without actually stopping and restarting
it. B.
Send the data directly to the packet encoder inside the
flow graph such that it follows the same operational path as the original file
source data so that the result is the same and the data is packetized,
modulated, and sent out through the USRP. |
[Prev in Thread] | Current Thread | [Next in Thread] |