[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Questions regarding interpolator and usrp.sink_c conf
[Discuss-gnuradio] Questions regarding interpolator and usrp.sink_c configuration
Thu, 10 Sep 2009 15:28:47 -0700
Thunderbird 220.127.116.11 (X11/20090817)
Here I have a couple of questions during my project:
1, I am receiving "uU"(usrp underrun) when I am transmitting, it seems
that the data rate I feed to DAC is less than 128MS/s? I've already set
the maximum interpolation rate at 512. What's the problem might be? I
guess the input data rate of usrp.sink_c is too low. If so, is there any
block plays the function of interpolator? If I have errors in my
reasoning or consumption, please point me out.
2. Since the block : usrp.sink_c doesn't have the parameter of Tx
frequency in its parameter list. Is that means I have to define a
function like set_freq() and call it? Is there anyway I could set a
fixed tx frequency in python without input that from the command line
option. I only have one daughterboard RFX2400.
Any suggestions and advice will be appreciated.
|[Prev in Thread]
||[Next in Thread]|
- [Discuss-gnuradio] Questions regarding interpolator and usrp.sink_c configuration,
Milo Wong <=