Re: [Discuss-gnuradio] USRP in TDD mode

[Andrey A]

Stefan,
Thanks for reply. I tried std_2rxhb_2tx.rbf firmware from gnuradio 3.2.2 and results are the same. Without enabling transmitter at the receiver the received signal range is [-15e3; +15e3], and after enabling transmitter it became [-2400; +2400].
The workaround you mentioned is not applicable in my situation, since I need to receive and transmit from the same antenna.

I'm not sure if I enable receiver and transmitter simultaneously in the right way.

Thanks.

On Tue, Sep 22, 2009 at 9:55 PM, Stefan Brüns <address@hidden> wrote:

On Tuesday 22 September 2009 19:47:10 Andrey A wrote:
> Hello.
> I'm trying to build a two-way TDD system with two USRP1 boxes in pure C++
> using libusrp and inband_2rxhb_2tx.rbf firmware.

IIRC the ib firmware has a bug not switching the antennaes correctly.
Workaround: set RX antennae to RX2 and connect an antenna to each port.

Stefan

--
 Stefan Brüns  /  Bergstraße 21  /  52062 Aachen
phone: +49 241 53809034   mobile: +49 151 50412019


_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio