[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] 250MHz signal generation using Basic TX

From: S'dir
Subject: Re: [Discuss-gnuradio] 250MHz signal generation using Basic TX
Date: Tue, 30 Mar 2010 13:39:15 +0530

Thank you Josh,

Appreciate if you through a light on  "the instructions for using the external clock for the usrp board"

Thanks & Regds,

On Tue, Mar 30, 2010 at 9:38 AM, Josh Blum <address@hidden> wrote:

On 03/29/2010 08:11 PM, S'dir wrote:


I have an USRP Rev-4.5 board, which contains two daughter boards, Basic TX
and BasicRX. According to the TX and RX Daughterboards data sheet, the TX
daughter board is capable of generating  up to 1 MHz to 250 MHz signal.

I am unable to generate transmit signal more than 44MHz using the
usrp_siggen.py program which comes with the Gnu Radio software development
kit to generate the Transmit signal.

The DAC rate is 128 Msps. Technically, you cannot have frequencies above the nyquist rate of 64 MHz. The basic tx relies on aliasing to get anything above that rate. Take a look on a spectrum analyzer when transmitting, you should see the signal and its aliases. -Josh

Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]