discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] find_usrps "No USRP2 found."


From: Jason Abele
Subject: Re: [Discuss-gnuradio] find_usrps "No USRP2 found."
Date: Sat, 24 Apr 2010 08:24:12 -0700

Steve,

If you have GNUradio trunk installed, did you update your SD card with
a firmware from:

http://gnuradio.org/releases/usrp2-bin/trunk/

You'll need txrx_wbx.bin

Jason

On Fri, Apr 23, 2010 at 10:56 PM, Steve Glass <address@hidden> wrote:
> Hi,
>
> I've just received my USRP2 and WBX. Using the Ettus SD Card the USRP2
> switches on, six LEDs briefly light and then just D and F remain lit.
>
> Connect the USRP2 directly between T61 and USRP2 and both ethernet ports
> have a green LED showing a solid light.
>
> GNURadio trunk is installed so I run find_usrps and get this:
>
> [10001]>find_usrps
> No USRP2 found.
> [100002]>
>
> The second USRP2 ethernet port LED flashes orange when I run find_usrp2.
> In WireShark and see a request packet get sent out but get no reply. The
> interface is configured as follows:
>
> [10002]>ifconfig eth0
> eth0      Link encap:Ethernet  HWaddr 00:1e:37:1e:23:9c
>          inet6 addr: fe80::21e:37ff:fe1e:239c/64 Scope:Link
>          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>          RX packets:0 errors:60 dropped:0 overruns:0 frame:60
>          TX packets:111 errors:0 dropped:0 overruns:0 carrier:0
>          collisions:0 txqueuelen:1000
>          RX bytes:0 (0.0 B)  TX bytes:13234 (12.9 KiB)
>          Memory:fe000000-fe020000
>
> [100003]>ethtool eth0
> Settings for eth0:
>    Supported ports: [ TP ]
>    Supported link modes:   10baseT/Half 10baseT/Full
>                            100baseT/Half 100baseT/Full
>                            1000baseT/Full
>    Supports auto-negotiation: Yes
>    Advertised link modes:  1000baseT/Full
>    Advertised pause frame use: No
>    Advertised auto-negotiation: Yes
>    Speed: 1000Mb/s
>    Duplex: Full
>    Port: Twisted Pair
>    PHYAD: 1
>    Transceiver: internal
>    Auto-negotiation: on
>    MDI-X: off
>    Supports Wake-on: pumbag
>    Wake-on: g
>    Current message level: 0x00000001 (1)
>    Link detected: yes
>
> Would be grateful for any advice on how to get find_usrps to discover
> the device.
>
> Regards
>
> Steve
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>




reply via email to

[Prev in Thread] Current Thread [Next in Thread]