[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] USRP2 UHD Matlab Receiver Communications Blockset

From: Vincent W
Subject: Re: [Discuss-gnuradio] USRP2 UHD Matlab Receiver Communications Blockset
Date: Fri, 10 Sep 2010 02:23:31 -0400
User-agent: Mozilla/5.0 (X11; U; Linux x86_64; en-US; rv: Gecko/20100806 Lanikai/3.1.2

On 09/10/2010 12:55 AM, Josh Blum wrote:
> On 09/09/2010 06:43 PM, Vincent W wrote:
>> Hi,
>> I stumbled on this blockset on the Matlab website:
>> http://www.mathworks.com/help/toolbox/commblks/ref/usrp2receiver.html
>> I've been making do with the old firmware and fpga, but when I saw this 
>> link, I
>> became really excited - especially because it implies I can decrease the
>> decimation on my USRP2 to 1 - perhaps by requesting real, single precision
>> values instead of complex doubles.
> The minimum sustainable sample rate over the wire is 25Msps for the UHD 
> (unless
> you change FPGA implementation). I dont know what FPGA code "they" are using.
> Also, I dont think these simulink blocks have UHD under the hood.
>> Is there an open source version of that blockset?
>> Alternatively, despite poking around the UHD API, it wasn't immediately 
>> obvious
>> how I could change the type of data, or set a decimation of 1, from the
>> uhd::usrp::simple_usrp class. I suspect it may have something to do with the
>> uhd::io_type_t class, but, again, I'm not too sure.
> The device::send and device::recv calls take the IO type as an argument. The
> samples are converted between IO type and over-the-wire type in the UHD
> implementation code.
> -Josh

I stand corrected; it seems like they are using the udp drivers, as opposed to
the uhd drivers.

My bad.


reply via email to

[Prev in Thread] Current Thread [Next in Thread]