[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] UHD: tx - sync via MIMO cable, rx - "We're markin
Re: [Discuss-gnuradio] UHD: tx - sync via MIMO cable, rx - "We're marking it DONE"
Wed, 03 Nov 2010 09:52:55 -0700
Mozilla/5.0 (X11; U; Linux i686; en-US; rv:220.127.116.11) Gecko/20101006 Thunderbird/3.1.5
The mimo cable has not been addressed in UHD ATM. To receive from
multiple usrps in a synchronized manner, you will need to feed each PPS
and reference input appropriately according to the following docs:
In the flow graph, one of the blocks should be set to "sync on unknown
pps". If the times across the usrps are not synchronized, then the
stream request will probably fail and the usrps will not stream in unison.
On 11/03/2010 09:11 AM, Veljko Pejovic wrote:
Setup: Two USRP2 + WBX boards, one PC with Ubuntu 10.04, the latest
gnruadio/next and uhd from the github. The PC hosts two PCI express
GigEthernet cards, which are connected to the two USRP2s.
I'm using UHD to tx/tr with two boards simultaneously. I'm working
with Multi USRP source and sink from the GRC. I have two problems in
1) The tx part works except for the synchronization. I have a MIMO
cable and I though about using it for that. However, it seems that
Multi USRP sink does not see the cable. Is it possible to use this
cable for sync purposes? Alternatively, is there a way to get rid of
the one of the GigE cards and get the data through the mimo cable to
the other device (I know that this is the original MIMO cable idea,
it's just that I haven't heard about any successful attempts).
2) The receiver gives me this nasty "We're marking it DONE" error
message, that a few people reported earlier. Before trying out some of
the posted solutions, are there any solutions to the problem that do
not require changing C code and recompiling the whole thing?
Discuss-gnuradio mailing list