Re: [Discuss-gnuradio] UHD Driver in E100/Beagleboard

[Ben Hilburn]

Hrm, I just realized that I should clarify something:

I can use UHD + E100 no problem.  I have _not_ tested UHD + GNURadio +
E100 recently.

Sorry for the confusion!

Cheers,
Ben


On Thu, Feb 24, 2011 at 1:21 AM, Ben Hilburn <address@hidden> wrote:
> I cannot comment on the Beagleboard, but using UHD on the E100 works
> great for me.  I have been using it reliably for the last few weeks.
> I haven't rebuilt UHD in probably a week and a half or so, but I was
> planning on doing that in the next couple of days using the next
> branch.
>
> I'll let you know if I run into issues, but right now everything is
> smooth sailing.
>
> Cheers,
> Ben
>
>
> On Wed, Feb 23, 2011 at 11:25 PM, Almohanad Fayez <address@hidden> wrote:
>> I was wondering about people's experience with the UHD driver on the E100 or
>> the Beagleboard.  I am able to use it to receive IQ data from the USRP but I
>> can't seem to transmit anything from it ... if I take the same flowgraph to
>> a laptop I'm able to transmit IQ using the same USRP/daughterboard and the
>> UHD driver however when I try to run the same transmitter on the Beagleboard
>> and I check my spectrum analyzer I don't see anything
>>
>> I already did a signal capture before sending to the USRP and made sure that
>> there is data getting pushed through ... is there a problem with UHD/USRP
>> sinking on the E100 and the Beagleboard ???  I also made sure that I'm using
>> the latest UHD firmware on the beagleboard.
>>
>>
>> The following is the version info printed when I run the flowgraph:
>> linux; GNU C++ version 4.5.3 20110214 (prerelease); Boost_104500;
>> UHD_0001.20110224034946.1
>>
>>
>> thanks
>>
>> al fayez
>>
>>
>>
>> _______________________________________________
>> Discuss-gnuradio mailing list
>> address@hidden
>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>>
>>
>