discuss-gnuradio
[
Top
][
All Lists
]
Advanced
[
Date Prev
][
Date Next
][
Thread Prev
][
Thread Next
][
Date Index
][
Thread Index
]
[Discuss-gnuradio] Receive GPS L1 Signal
From
:
Eddie Sun
Subject
:
[Discuss-gnuradio] Receive GPS L1 Signal
Date
:
Sun, 12 Jun 2011 00:12:23 +0800
Hi all,
I have a USRP N210 and DBSRX2 daughter board, running on Ubuntu 10.04, and I would like to get the L1 signal by
using Gnuradio Companion to draw a GPS receiver flow graph (I have a GPS Antenna), and I just need to get the IF signal into File
Sink to get the .dat so I can use MATLAB to deal with the data, I have a book "A Software-Defined GPS and Galileo Receiver: A
Signal-Frequency Approach", there is a GNSS L1 front-end digram at p.55 (that is my only reference), but I have no idea how to
translate it into GNUradio Blocks.There is a ADC on that diagram, should I just ignore it, or I need some blocks to complete that ADC?
(There is no blocks called ADC)And there is several Band-Pass Filter in the diagram with center frequency and 3dB Bandwidth, but I
don't know how to translate it to the information that blocks needed.(Like Low or High cutoff frequency, transition width ...etc)
Can anyone help me? Or has an example .grc or some website for related information?
Thanks,
Eddie
reply via email to
[Prev in Thread]
Current Thread
[
Next in Thread
]
[Discuss-gnuradio] Receive GPS L1 Signal
,
Eddie Sun
<=
Re: [Discuss-gnuradio] Receive GPS L1 Signal
,
John Andrews
,
2011/06/20
Re: [Discuss-gnuradio] Receive GPS L1 Signal
,
Eddie Sun
,
2011/06/24
Re: [Discuss-gnuradio] Receive GPS L1 Signal
,
Marcus D. Leech
,
2011/06/24
Prev by Date:
Re: [Discuss-gnuradio] error correcting codes block
Next by Date:
Re: [Discuss-gnuradio] error correcting codes block
Previous by thread:
[Discuss-gnuradio] gr-uhd patch
Next by thread:
Re: [Discuss-gnuradio] Receive GPS L1 Signal
Index(es):
Date
Thread