On Tue, Dec 6, 2011 at 5:21 AM,
<address@hidden> wrote:
Hello all,
I was using usrp2_rx_cfile.py module to sense 2.4G channel by using RX2400 board(2.2G to 2.9G). Now I want to sense TV frequencies so I have changed the daughter board to wbx daughter board ( 50 MHz to 2.2G). But now I cannot sense the signal by using coaxial cable connected to my usrp2 box and on the other end connect to antenna on the roof top. I have tested that there is a TV signal by plugging the cable into my signal analyser but my program cannot sense that signal.
Regards,
Umer Rabbani | Researcher
Umer,
It looks like you are using the older libusrp2 code (usrp2_rx_cfile instead of uhd_rx_cfile). If that's the case, there are different images you need on the SD Card in the USRP2 to work with the WBX board.
Tom