[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Help please!

From: Almohanad Fayez
Subject: Re: [Discuss-gnuradio] Help please!
Date: Fri, 3 Feb 2012 13:17:31 -0500 (EST)

Javier, the RFX2200 daughterboard works in the following frequency range
2.0–2.4 GHz you're trying to use it outside the supported frequencies (2.45GHz and 93.3 MHz) you should either work with the supported frequencies or buy a different daughterboard to work with those frequencies

Almohanad Fayez

-----Original Message-----
From: Javier Suarez <address@hidden>
To: discuss-gnuradio <address@hidden>
Sent: Fri, Feb 3, 2012 11:50 am
Subject: [Discuss-gnuradio] Help please!

Good morning,
I am working with Gnuradio +UHD version 3.5.1, the daughter boardas are RFX 2200 and frequency: 2400 - 25000 MHz.I want to make a simple spectrum analizer, I tried to do it by myself but I always had a mistake. Then I started to try with an example who came with it  which is uhd_ fft.grc but I had the same mistake too:

linux; GNU C++ version 4.4.3; Boost_104000; UHD_003.004.000-5b06adb

-- Opening a USRP1 device...
-- Using FPGA clock rate of 64.000000MHz...

UHD Warning:
    The hardware does not support the requested RX frequency:
    Target frequency: 2450.000000 MHz
    Actual frequency: 2386.000000 MHz
thread[thread-per-block[0]: <gr_block gr uhd usrp source (12)>]: caught unrecognized exception

On the other hand,
 I tried to test the wbfm receiver, other example that came with the software, tunning at 93.3 MHz but this mistakes appears:

UHD Warning:
    The hardware does not support the requested RX frequency:
    Target frequency: 93.300000 MHz
    Actual frequency: 2013.300000 MHz

I was expecting to see something in the spectrum analyzer at 93.3 and listening something.

I don't know what to do, I've tried a lot but I don't know why it says that the hardware doesnt support the frequency

Thanks a lot in advance

Javier M.
Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]