[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] WBX Transmit Power Issue

From: Reginald Cornwallice
Subject: Re: [Discuss-gnuradio] WBX Transmit Power Issue
Date: Mon, 13 Feb 2012 08:28:22 -0500

Yes, I am sure I am connected to the right connector. My carrier is in the 800 MHz band.

Thank you,

On Fri, Feb 10, 2012 at 4:51 PM, Ed Criscuolo <address@hidden> wrote:
I know this is a stupid question, but I've been bitten by this before:

Are you SURE you're cabled to the Tx/Rx connector and not Rx2?

@(^.^)@ Ed

On 2/10/12 4:30 PM, Reginald Cornwallice wrote:
Hello All,

I'm having an issue with the transmit power on N210 + WBX not being able
to reach the spec'd 100 mW on the data sheet.

I'm transmitting a PN sequence at a rate of 1.2 Mchips/second. The
values I'm sending to the DAC are +/- 24000 which is a little
bit below the full range of the DAC, but not much. I've set the TX_GAIN
parameter to its maximum value of 25.

I measure the output transmit power with a ladybug powermeter and get
-15 dBm peak power. This is well below the spec of 20 dBm.
Any ideas out there what could be wrong? Does the tx_gain of 25 set all
the gains of the LO, IQ modulator, etc? What is controlled and set by
setting set_tx_gain to 25?



Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]