On Mon, Mar 5, 2012 at 4:19 PM, Jiao Xianjun
<address@hidden> wrote:
Hi,
I just got a USRP N210 rev4.0, and install gnuradio+uhd with this script: http://www.sbrac.org/files/build-gnuradio in Ubuntu 11.10 (32bit).
My eth config is:
eth0 Link encap:Ethernet HWaddr 00:0c:29:2d:a9:f8
inet addr:192.168.10.1 Bcast:192.168.10.255 Mask:255.255.255.0
inet6 addr: fe80::20c:29ff:fe2d:a9f8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2213 errors:0 dropped:0 overruns:0 frame:0
TX packets:2997 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1829471 (1.8 MB) TX bytes:343606 (343.6 KB)
Interrupt:19 Base address:0x2024
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1650 errors:0 dropped:0 overruns:0 frame:0
TX packets:1650 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:123948 (123.9 KB) TX bytes:123948 (123.9 KB)
and I do can ping 192.168.10.2:
PING 192.168.10.2 (192.168.10.2) 56(84) bytes of data.
64 bytes from 192.168.10.2: icmp_req=1 ttl=32 time=2.05 ms
64 bytes from 192.168.10.2: icmp_req=2 ttl=32 time=1.75 ms
64 bytes from 192.168.10.2: icmp_req=3 ttl=32 time=1.93 ms
64 bytes from 192.168.10.2: icmp_req=4 ttl=32 time=1.80 ms
64 bytes from 192.168.10.2: icmp_req=5 ttl=32 time=2.04 ms
64 bytes from 192.168.10.2: icmp_req=6 ttl=32 time=1.94 ms
64 bytes from 192.168.10.2: icmp_req=7 ttl=32 time=2.01 ms
64 bytes from 192.168.10.2: icmp_req=8 ttl=32 time=1.78 ms
^C
but when I run uhd_find_devices, the outputs are:
linux; GNU C++ version 4.6.1; Boost_104601; UHD_003.004.000-307-gb61f4ad6
No UHD Devices Found
Any one can help me, or give me some information?
Thank you so much!
BR
putaoshu