[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] setup of usrp N100/N200

From: Sandhya G
Subject: Re: [Discuss-gnuradio] setup of usrp N100/N200
Date: Mon, 21 Oct 2013 10:21:43 +0530

Thanks for the reply.
Well is that only problem so that i'm unable to communicate and should i need to update the firmware?

Thanks and regards

On Mon, Oct 21, 2013 at 10:19 AM, Activecat <address@hidden> wrote:
Your pc must have 1000Mbps port. The 10/100Mbps won't work.
An alternative is to connect a 10/100/1000 LAN switch between your pc and the USRP.


On Mon, Oct 21, 2013 at 12:37 PM, Sandhya G <address@hidden> wrote:

HI all,

I have followed as per the instructions given in the webpage for set up of the Usrp N200/N210 but still i am unable to communicate between the  hardware and host pc


                1.I have set the static ip of the host pc to eth0

2.Whenever i give the device address=addr= and run the grc i am getting the error has “unknown key format” 

3.Whenever i ping or use the command  uhb_find_device  i am getting warning as “NO DEVICE FOUND

4. Is that a must i have to upload the fpga and firmware images when using the device for the first time.

5.Sometimes i am getting an error like” unable to find as single device”.

6.The host pc is supporting only 10/100MBPS .Is that the only problem so that i am unable to communicate with the hardware.


Can anybody help me on this issue.Awaiting for your valuable reply

Thanks in advance 


Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]