[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] Decoding FSK modulated signal
From: |
Andre Puschmann |
Subject: |
[Discuss-gnuradio] Decoding FSK modulated signal |
Date: |
Mon, 14 Apr 2014 13:25:48 +0200 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:24.0) Gecko/20100101 Thunderbird/24.4.0 |
Hey,
I've some home automation equipment here using the sub-ghz band that I
managed to capture with a RTL dongle. From the data sheet and the
register settings of the TI CC1100 transceiver chip that is used inside
the device I figured out the RF parameters used, i.e. 102kHz channel
bandwidth, 2-FSK modulation, 19.2k baudrate, syncbyte etc.
Attached is a screenshot of a GRC waveform I used to capture the
preamble of a single packet. Channel 2 is simply the output of a
quadrature demod block connected to a scope GUI block. I'd like to
decode that into a sequence of bits to run preamble detection etc.
I've seen a few OOT modules that do similar stuff but was wondering if
there is a GR'ish way to this, maybe a set of generic blocks that could
be used for that?
Thanks
Andre
[1] http://i61.tinypic.com/35mjm08.png
- [Discuss-gnuradio] Decoding FSK modulated signal,
Andre Puschmann <=