[Discuss-gnuradio] Flow graph blocking when doing 2x1 transmission

[David Halls]

Dear All,

 

I am using N210s with XCVR2450s. I have successfully performed 2x1 transmission, but not I am not transmitting the same stream over both transmitters. One stream is constantly available, and is no problem. The second stream only starts later on, and thus it is blocking the flow graph. I tried using a mux for the second stream with some noise so that it will transmit noise for the first X samples, and then the second stream, but this doesn’t work either.

 

Any suggestions guys?

 

David

---

NOTE: The information in this email and any attachments may be confidential and/or legally privileged. This message may be read, copied and used only by the intended recipient. If you are not the intended recipient, please destroy this message, delete any copies
 held on your system and notify the sender immediately.

Toshiba Research Europe Limited, registered in England and Wales (2519556). Registered Office 208 Cambridge Science Park, Milton Road, Cambridge CB4 0GZ, England. Web: www.toshiba.eu/research/trl

---

This email has been scanned for email related threats and delivered safely by Mimecast.
For more information please visit http://www.mimecast.com

---