Re: [Discuss-gnuradio] Installing Channel Coding Toolbox on Windows GNURadio

[Nguyễn Văn Lý]

Hi Marcus,

I'm using Encode CCSDS 27 and Decode CCSDS 27, but I don't know how to handle with the requirement of "float" input in the Decode CCSDS 27. I tried to make a conversion block to convert bit to float (0 becomes -1 and 1 still becomes 1), but that did not work correctly.

In the flow graph that I attached, the Btf_Conversion block is to converts bits to floats and the Console Sink sink is just to print out what it receives.

Best Regards,

V-L

Van-Ly Nguyen,

Signals and Systems of Laboratory - SSL  

Faculty of Electronics and Telecommunications - FET         

University of Engineering and Technology - UET      

Vietnam National University, Hanoi - VNU  

Tel: (+84) 978 819 406

On Wed, Jul 2, 2014 at 2:41 PM, Marcus Müller <address@hidden> wrote:

That cgran page says "GNU Radio >= 3.2.2", which indicates it might be terribly outdated and would not work with 3.6.5 (it can't work with 3.7); I don't know if Nico has touched the code base since 2011, but I assume you'll have to go great lengths to get it to work with current GNU Radio versions.

Try the new gr-fec interface, now included in GNU Radio 3.7; it might suit your needs!

Best Regards,
Marcus

On 02.07.2014 03:54, Sun Wenbin wrote:

Dear all,
I am trying to install this toolbox https://www.cgran.org/wiki/chancoding. However, I am working on a windows environment GNU Radio, do anyone tried before or knows how can I get it installed on a GNU Radio?
Thank you.
Regards,Sun 		 	   		  

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

myfile3.grc.png
Description: PNG image