discuss-gnuradio
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] FSK receiver


From: Hoang Nguyen Tran
Subject: Re: [Discuss-gnuradio] FSK receiver
Date: Sat, 5 Sep 2015 09:11:35 -0400

Thank you Marcus.

On Thu, Sep 3, 2015 at 4:05 AM, Marcus Müller <address@hidden> wrote:
Hoang,

there's the frequency modulator block. I think this is what you're looking for.

Best regards,
Marcus


On 03.09.2015 07:03, Hoang Nguyen Tran wrote:
Hi Rich,
I am continue with the transmitting part ?
However, I cannot fine the FSK modulate block or Quadrature mod in GNU radio companion.
Is there another block that use for FSK modulation in GNU radio ? I found DPSK mod, GFSK mod, GMSK mod ... however not FSK.
Do you have any example for transmitting flow graph in GNU radio with USRP ? If yes, could you please give any hint ?
Thank you and best regard
Hoang

On Mon, Aug 31, 2015 at 7:31 PM, Hoang Nguyen Tran <address@hidden> wrote:
Thank you Rich,
I have added Rational Resample with the formular : Fs_out = Fs_in x Interpolation / Decimation
Then the grc run without error.


On Fri, Aug 28, 2015 at 7:03 PM, Richard Bell <address@hidden> wrote:
Hi Hoang,

Yes it's a problem with your design. You have 2 Msps feeding into an audio sink that probably goes up to 48 ksps. You need to change your sample rate from 2 Msps to a rate your sound card supports. I would target one of the default rates you can select from the audio sink. You can use polyphase arbitrary resampler block with the proper resampling ratio 2M/48k entered leaving the taps blank and the other parameters to default.

Hope that helps,
Rich

On Fri, Aug 28, 2015 at 2:19 PM, Hoang Nguyen Tran <address@hidden> wrote:
Dear all,

I have just built a FSK receiver aim to receive Cubesat data with FSK modulation with 9600 baud rate, below is my flow graph.
I have just tested it with usb dongle RTL-SDR, however when I'm using audio sink, I received  OOOOO (overrun I think) continuously .
Does it have anything wrong with my set up ?

samplerate 2M
cut off freq 9600
transition 4800

I really appriciate for any comment on my FSK receiver flowgraph, I am a newbie :)

Thank you and best regard,
Hoang

--
 -HoangNT-
PhoneNo :  +841654248782
Skype : hoangastro

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio





--
 -HoangNT-
PhoneNo :  +841654248782
Skype : hoangastro



--
 -HoangNT-
PhoneNo :  +841654248782
Skype : hoangastro


_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio


_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio




--
 -HoangNT-
PhoneNo :  +841654248782
Skype : hoangastro

reply via email to

[Prev in Thread] Current Thread [Next in Thread]