Marcus,
That extremely low signal level is due to a Multiply Const block in
the flow graph set to 0.00055242272. In the gr-dtv in-tree version,
I've deleted that block.
Ron
On 12/17/2015 02:25 AM, Marcus Müller
wrote:
Can you crank up the USRP gain further? An average PSD value of
10^-14 indicates there's still room for amplification, maybe. What
Daughterboard are you using?
Just out of interest, because improvised a ~760MHz monopole
antenna not so long ago: What kind of antenna are you using?
Best regards,
Marcus
Hello all,
Here are the USRP setting for my flowgraph
USRP N210 Settings
Sampling Rate: 10M
Center Frequency :746MHz
Gain:19
The broadcast station has these parameters
Frequency:746MHz
Code rate : 2/3
Guard interval : 1/4
Transmission mode : 8k
I tried the vector to stream trick but doesnt works. Also I tried using
the OFDM synchronization block from gr-isdbt it also doesnt works. The
signal capture according to me is very good I have its screenshot
attached. Any other tips to get the flowgraph running? Thanks all
Cheers
Ahsan
|