[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Synchronization within the same USRP

From: Marcus Müller
Subject: Re: [Discuss-gnuradio] Synchronization within the same USRP
Date: Sat, 15 Oct 2016 11:20:02 +0200
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:45.0) Gecko/20100101 Thunderbird/45.3.0

Dear Adel,

well, it's hard to tell why you lose sync if you don't share your flow graph, what kind of channel you have, and an overall overview of your system.

Anyway, synchronizers do work with stochastic properties of the receive signal. There's absolutely no 100% guarantee sync stays on forever; it's a stochastic thing that the communication engineer needs to optimize to work best with the signal and channel.

Best regards,


On 15.10.2016 05:36, Aldalbahi, Adel wrote:

Dear All, 

I have been working with a single USRP N210 to measure BER using BER Error block. The communication is working perfect and I can transmit and receive. Also I can see the constellation points of 4PSK at the receiver. One thing I was totally confused about is that how to synchronize both tx and rx blocks using single usrp? I used polyphase clock, equalizer, also costa loop but still I lose synchronization after few seconds? is there is anyway or example I can look at to help me solve this problem? since I know I have phase offsite because of the channel but how to solve this ? How to solve the delay problem  between tx and rx?  

Thank you in advance. 

Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]