[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Tunnel.py with USRP x310
From: |
Danilo De Donno |
Subject: |
Re: [Discuss-gnuradio] Tunnel.py with USRP x310 |
Date: |
Fri, 2 Dec 2016 13:57:01 +0100 |
Hi Julian,
for now, I'm using the 1Gbit Ethernet interface. I'll run bechmark_rate and
also update UHD to 3.9 LTS as well, and let you know.
Thanks a lot for the advice.
Anyway, what should be the configuration to run tunnel.py? I mean, could you
tell me how to connect the PCs, USRPs, and switch each other?
Best,
Danilo
-----Messaggio originale-----
From: Julian Arnold
Sent: Friday, December 02, 2016 1:49 PM
To: address@hidden
Cc: address@hidden
Subject: Re: [Discuss-gnuradio] Tunnel.py with USRP x310
Hi Danilo,
Just to get it right, so far you have one USRP attached to a PC using a
switch? Is it a gigabit switch? Have you tried to run something like
benchmark_rate to see if the connection works fine?
Also, at the moment I would recommend using the LTS version of UHD 3.9.
Cheers,
Julian
Danilo De Donno schrieb am 01.12.2016 17:21:
Hi Julian,
I’m using UHD 3.9.1. For now, I’m trying to run the example with only 1
PC, so I have the PC and the USRP both connected to a network switch.
Then, I plan to add the second PC with its USRP to the switch as well. I
think it’s should be the configuration in order to have two PCs with
different IPs belonging to the same subnet, right? However, I’m not
expert, so any advice is more than welcome.
Best,
Danilo