[Discuss-gnuradio] Overlapping blocks and wires bug

[Bakshi, Arjun]

Not sure if this is the right place, but a couple of annoying behaviors of GRC.

Often times when one adds a block to the flowgraph in GR, it'll go over a wire or under another block.

When it goes over a wire, often times clicking on the block will select the wire underneath it, and move or disconnect it. The block on top should always be selected, not the obscured part of the wire.

When it goes under existing blocks, it's just hard to find.

I'm experiencing this in version 3.7.10.1.

Thanks,

AB