[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Discuss-gnuradio] Installing GNURadio On Raspberry Pi

From: Ron Economos
Subject: Re: [Discuss-gnuradio] Installing GNURadio On Raspberry Pi
Date: Wed, 24 Apr 2019 23:08:28 -0700
User-agent: Mozilla/5.0 (X11; Linux x86_64; rv:60.0) Gecko/20100101 Thunderbird/60.6.1

Building on ARM isn't that horrible. On a BeagleBoard-X15, I can build GNU Radio from source in 2 hours, 12 minutes. That's with 2 GB of RAM and 2 GB of swap on SD card.


On 4/24/19 01:05, lists wrote:
I built it on a beagle board black, which is not as powerful as a RPI these 
days. This isn't all that fresh in my memory.

I don't recall having to set up VM beyond stock. Slow compilation...well yeah!

It might just be me, but the only signal processng I ever found useful on those 
SBCs was ADSB decoding. Rtlsdr and some flavor of dump1090.

          Original Message

From: address@hidden
Sent: April 24, 2019 12:51 AM
To: address@hidden; address@hidden; address@hidden
Subject: Re: [Discuss-gnuradio] Installing GNURadio On Raspberry Pi


On Tue, 2019-04-23 at 19:31 -0700, lists wrote:
uhhh that wiki page is ... dated. It also doesn't solve the issue of
not being able to import gr-osmosdr, which isn't part of GNU Radio

Also, clearly *not* the way I'd recommend on a raspberry Pi:

What lazygranch recommends is a source build, which takes roughly
forever on a raspberry Pi, and requires use of copious amount of swap
memory, due to the limited amount of RAM of a Raspberry Pi.

So, if you can, get a binary installation of GNU Radio. It seems you
already have one!

Then, you'll need to make sure you've got a working gr-osmosdr
installation on your Pi. How did you install GNU Radio and gr-osmosdr
on your Raspberry Pi so far?

Best regards,

Discuss-gnuradio mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]