Hi y'all,
It
comes with an example transceiver .grc, but made with USRP instead of
osmocom. I changed the source to osmocom (parameters are mostly the same), and disabled the sink, since HackRF is only half-duplex. Only problem is, now I've got this "Wifi PHY Hier" block that's angry at me because I disabled its output target.
What can I plug in there, just as a placeholder while I verify the reception end? The flowgraph output is colored blue in the gui, if that helps.
Thanks!
--
Eamon Heaney
Fleet Commander
President, Model UN at Virginia Tech