[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: About the transceiver and sending packets to / from a hardware
From: |
Marcus Müller |
Subject: |
Re: About the transceiver and sending packets to / from a hardware |
Date: |
Sat, 15 Feb 2020 21:39:41 +0100 |
User-agent: |
Mozilla/5.0 (X11; Linux x86_64; rv:68.0) Gecko/20100101 Thunderbird/68.2.2 |
Hi,
slightly will have to repeat myself:
On 15.02.20 21:15, sampath ranga wrote:
> Hello Everyone,
>
> 1. I was trying for the past few weeks to make the Zigbee Trx
> communicate with the other Zigbee hardware for implementation
> verification . I am not using TelOS b mote with COntiki Firmware
> instead i am using a Zigbee dongle as a hardware to make the
> communication work . My question is why is the flowgraph restricting
> only to hear the "hello world" message but not the message from other
> hardware? If my SDR could operate at 2.4GHz in air , the transceiver
> block should not only hear the "GNU Radio Transmitted message but also
> from the other hardware isnt it? The other hardware is also not
> receiving the GNU Radio's message.
This is wireless communications. Not only do you have to configure all
devices in a compatible manner, channel and receiver conditions can make
interoperation problematic.
You will have to apply your own signal processing / wireless education
to debug this.
> 2. Is the Rime stack / MAC layer that fixes frames stopping the
> other hardware to send or receive?
I don't understand this question, sorry.
> 3. I am also trying the same Zigbee Trx in 2 laptops, the message
> that i set in laptop 1 at GNU Radio Zigbee TRX has been received in
> wireshark at laptop 1 and laptop 2 message at laptop 2 , Why are not
> they syncing with each other if i give same destination or pan id with
> channel number?
Same answer as to 1. You're not doing any signal-level debugging on
this, so we can't help you.
> Technically i am trying to do 2 work , Either have two laptop that has
> each flowgraph with 2 different message and wanna see if they both are
> transferring their message at wireshark, which is right now not happening
Same answer as to 1.
> secondly , trying to transmit Zigbee Trx basti's message to a seperate
> zigbee hardware (Xbee or any zigbee sniffer) or send message from Xbee
> and trying to receiving in on Wireshark at the GNU Radio end
Same answer as to 1.
> I also face the issue of when i transceive the message its showing
> "Bad FCS" and also the packet flow is getting stopped when i open the
> wireshark . Please throw some ideas on this .
>
Same answer as to 1.
smime.p7s
Description: S/MIME Cryptographic Signature