Re: How ensure consistency with timing signals

[Marcus D. Leech]

On 02/26/2020 04:11 PM, Lukas Haase wrote:
> Hi Marcus,
>
> Good point; but this is just for demonstration purposes here. I can tie it to 
> USRP Source/Sink.
>
> The delta (measured in samples) should still be consistent, no matter what.
>
> Best, Lukas
Looking at the siggen code, this is probably equivalent to phase-noise 
in the generator.  The square wave outputs are derived from COS/SIN, and
  at such a high ratio between sample rate and frequency, there'll be a 
bit of phase noise.

Someone with more knowledge of the siggen block can comment further.