Re: [USRP-users] Overrun on chan error 0 USRP e310 RFNoC

[Marcus D. Leech]

On 11/21/2020 06:53 AM, Ivan Zahartchuk wrote:

I was setting samp_rate to 1 msps and observed the same situation. In addition, in the example fosphor samp_rate = 56 msps and no errors occur.

If you replace the ZMQ blocks with NULL SINK blocks, do the overruns go away?

сб, 21 нояб. 2020 г. в 05:12, Marcus D Leech <patchvonbraun@gmail.com>:

There’s no way the fpga to ARM channel can support those data rates.  Lower your sample rate to 5msps and try again.

Sent from my iPhone

> On Nov 20, 2020, at 10:02 PM, Ivan Zahartchuk via USRP-users <usrp-users@lists.ettus.com> wrote:
>
> 
> Hello, I want to launch two channels for receiving in parallel with usrp e310 rfnoc. But on startup, I get an overrun error. What I need is uninterrupted data transmission for phase analysis on both channels. How can I do this?
> <Снимок экрана от 2020-11-21 04-50-17.png>
>
> <Снимок экрана от 2020-11-21 04-52-21.png>
>
> _______________________________________________
> USRP-users mailing list
> USRP-users@lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com