Re: GNUstep install on FreeBSD9.1

[Steven LeMaire]

Well, I really wanted to figure out where the problem with the port is, but unfortunately didn't find it.

I was still getting the error from configure that it couldn't properly compile an objective c program.

I did get GNUstep installed following the instructions linked below. Also, this was using binutils 2.22

http://brilliantobjc.blogspot.ca/

On 2013-04-08, at 4:04 AM, David Chisnall wrote:

On 8 Apr 2013, at 03:22, Steven LeMaire <photocdn@gmail.com> wrote:

I'm using the libobjc2 from ports. The distinfo file says its libobjc2-1.6.tar.bz2 Is this not correct ? Do i need to fetch one from svn somewhere ?

Yes, the one from svn is a better bet.  I am still chasing some MIPS bugs in either clang, rtld, or our processor, but once that's done I hope to cut the 1.7 release.

I believe my binutils is the stock one from freebsd 9.1, for example ld -v says its GNU ld (GNU Binutils) 2.22

FreeBSD 9.1 ships with binutils 2.17.  You've installed a newer one from ports, which conflicts with this.

David

-- Sent from my Cray X1