Re: Porting GNUstep to the RISC-V architecture

[address@hidden]

Hi Fred,

I did this change only in tools-make but then again I’ve built the whole 
GNUstep hierarchy at once using that compile-all script from tools-scripts. So 
I guess it might be different if you’re building those modules separately. I 
think it wouldn’t hurt to update the config.guess and the config.sub everywhere 
just to be safe.

kind regards,

        Lars

> Am 08.05.2022 um 22:24 schrieb Fred Kiefer <fredkiefer@gmx.de>:
> 
> OK, so I will undo my local change and instead update these two files. Was 
> that change needed for all GNUstep modules?
> 
> Fred
> 
>> Am 08.05.2022 um 05:15 schrieb lars.sonchocky-helldorf@hamburg.de:
>> 
>> From sheer excitement I forgot to answer your question: configure works fine 
>> so far even when not updating configure and configure.ac, e.g. replacing 
>> config.guess and config.sub with recent versions is just enough.
>> 
>> regards,
>> 
>>      Lars
>> 
>>> Am 08.05.2022 um 01:11 schrieb Fred Kiefer <fredkiefer@gmx.de>:
>>> 
>>> Lars,
>>> 
>>> could you please try whether it would be sufficient to just replace these 
>>> two file without updating configure and configure.ac?
>>> That update is fine for me, but it would stop people with an old autoconf 
>>> to regenerate the configure file.
>>> 
>>> Cheers,
>>> Fred
>