Re: Porting GNUstep to the RISC-V architecture

[Gerold Rupprecht]

Dear Lars, Fred, Gregory,

My congratulations to you and all other contributors in supporting the
RISC-V architecture.

Your professionalism shows through in the robustness and portability of
the code base.

Bravo!

Gerold


On 5/8/22 10:49 PM, lars.sonchocky-helldorf@hamburg.de wrote:
> Hi Fred,
>
> I did this change only in tools-make but then again I’ve built the whole 
> GNUstep hierarchy at once using that compile-all script from tools-scripts. 
> So I guess it might be different if you’re building those modules separately. 
> I think it wouldn’t hurt to update the config.guess and the config.sub 
> everywhere just to be safe.
>
> kind regards,
>
>       Lars
>
>> Am 08.05.2022 um 22:24 schrieb Fred Kiefer <fredkiefer@gmx.de>:
>>
>> OK, so I will undo my local change and instead update these two files. Was 
>> that change needed for all GNUstep modules?
>>
>> Fred
>>
>>> Am 08.05.2022 um 05:15 schrieb lars.sonchocky-helldorf@hamburg.de:
>>>
>>> From sheer excitement I forgot to answer your question: configure works 
>>> fine so far even when not updating configure and configure.ac, e.g. 
>>> replacing config.guess and config.sub with recent versions is just enough.
>>>
>>> regards,
>>>
>>>     Lars
>>>
>>>> Am 08.05.2022 um 01:11 schrieb Fred Kiefer <fredkiefer@gmx.de>:
>>>>
>>>> Lars,
>>>>
>>>> could you please try whether it would be sufficient to just replace these 
>>>> two file without updating configure and configure.ac?
>>>> That update is fine for me, but it would stop people with an old autoconf 
>>>> to regenerate the configure file.
>>>>
>>>> Cheers,
>>>> Fred
>
-- 
Gerold Rupprecht 
10, rue Louis-Curval
CH-1206 Genève, Suisse

Fixed: +41 (0) 22 347 73 96
Mobile: +41 (0) 79 914 29 52

Blog: https://geneva-observer.blogspot.ch/

GPG Key ID DFA0A4D4 I prefer encrypted mail.

If you have not yet begun using encrypted email, you may find the following 
link useful,
https://emailselfdefense.fsf.org/en/

geroldr.vcf
Description: Vcard