Re: seq; Error during initial package install

[Philip Kaludercic]

"Parker, Ron" <Ron.Parker@netapp.com> writes:

>>> The issue is that package.el is re-loading the built-in seq, but all the
>>> seq.el on ELPA does is try to load the right version of seq (for Emacs
>>> 24 or 25, as seen above).
>
>> I suspect the OP does not intend for `seq` to be fetched and reloaded
>> from ELPA, so the better fix might be to make sure `package.el` sticks
>> to the built-in `seq`.
>
> For my personal use, the built-in 2.23 version of seq is sufficient.
> However, the full case where I ran into this was installing ement.
> Its dependency chain is what is triggering the issue by pulling in
> seq 2.24 from ELPA.
>
> | ELPA Package    | Dependency      | ELPA Version |
> |-----------------+-----------------+--------------|
> | ement 0.15      | transient 0.3.7 |        0.6.0 |
> | transient 0.6.0 | seq 2.24        |         2.24 |

Can you try to apply the above patches and see if they help?


-- 
        Philip Kaludercic on barbet