Dear Espresso users,
Does anybody have experience with creating block-copolymers, using the polymer command?
I run into trouble when trying to specify interactions (bonded) for specific parts of the polymers (ie. the blocks). More specifically, is it possible to change the bond type for particular segments of the polymer, after it has already been set with the polymer command for the entire polymer?
Alternatively you can create blockcopolymers by using only the part command, and 'manually' linking the particles together to form blocks - but in that case you cannot, to my knowledge, make use of a random walk placement.
Any help is appreciated!
Regards
Koen Nickmans
--
The information contained in this message may be confidential and legally protected under applicable law. The message is intended solely for the addressee(s). If you are not the intended recipient, you are hereby notified that any use, forwarding, dissemination, or reproduction of this message is strictly prohibited and may be unlawful. If you are not the intended recipient, please contact the sender by return e-mail and destroy all copies of the original message.