[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [ESPResSo-users] Maze Constraints

From: Christian Holm
Subject: Re: [ESPResSo-users] Maze Constraints
Date: Tue, 9 Jul 2013 21:30:26 +0100


The Maze was implemented by Mehmet Sayar <address@hidden> long time ago. He is 
in cc and might know more. It was not used very much, to my knowledge.

With best regards


Institut für Computerphysik
Universität Stuttgart
Ph: +49-711- 685-63701

Am 09.07.2013 um 21:13 schrieb Axel Arnold <address@hidden>:

> Hi!
> The maze constraint is fairly old and I actually dont remember, who 
> originally implemented it.
> In any case, I am pretty sure that it simply fills a periodic simulation box, 
> and therefore neither allows to have only just the bottom filled only, nor 
> allows to fill only part of the box. If you need something like this, you 
> will have to modify the code. In particular, you will then need to think 
> about the surfaces of your maze, which because of the periodic boundary 
> conditions are not implemented yet.
> Regards,
> Axel
> On 07/09/2013 07:02 PM, Robyn Latimer (x2011ryq) wrote:
>> Hello everyone,
>> I'm looking into using the maze constraint for a simulation. I was wondering 
>> if anyone would be able to provide some clarification on a few points.
>> 1. I would like to have a 2 dimensional maze constraint at z=0, ie on the 
>> bottom of the box, is this possible? I haven't seen a place to input the 
>> location of the constraint.
>> 2. I do not want the maze constraint to be the length of the box. Ideally it 
>> would be half the size of the box, with one quarter of the box on either 
>> side. ( So the bottom of the box would be - regular constraint (25) maze 
>> constraint (50) regular constraint (25) with a total length of 100).
>> If anyone knows if this is possible help would be greatly appreciated.
>> Thanks,
>> Robyn
> -- 
> JP Dr. Axel Arnold
> ICP, Universität Stuttgart
> Pfaffenwaldring 27
> 70569 Stuttgart, Germany
> Email: address@hidden
> Tel: +49 711 685 67609

reply via email to

[Prev in Thread] Current Thread [Next in Thread]