[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [ESPResSo-users] particle does not exist

From: Stefan Kesselheim
Subject: Re: [ESPResSo-users] particle does not exist
Date: Tue, 17 Jun 2014 19:00:49 +0200

Dear Xikai,
please check the content of confout for particle 4633. There must be a section 
Are you sure that there is something like { particle 4633 pos 1 2 3 } in there?
Just after reading the configuration you should then be able to e.g. print its 
puts [ part 4633 print pos ]
and also to delete it. It is very likely that this is a simple error in your 
particle indexing or something similar. 
Cheers and good luck

On Jun 17, 2014, at 6:54 PM, Xikai Jiang <address@hidden> wrote:

> Dear all:
> I've got a question about deleting particles from a simulation continued
> from previous one.
> In the older simulation, I wrote blockfiles to store particle information 
> such as pid,
> positions, velocities.
> When the old simulation finished, I continued to run it by reading saved 
> blockfiles by
> the following command:
> set last [open "confout" "r"]
> while { [ blockfile $last read auto] != "eof" } { }
> close $last
> The simulation can continue running without problem, however, when I attempt 
> to
> delete a particle, it said "particle 4633 does not exist and cannot be 
> removed".
> I'm sure that particle 4633 exists in the saved configuration file.
> Does anyone encounter this problem before?
> Thanks for your time!
> XIkai

reply via email to

[Prev in Thread] Current Thread [Next in Thread]