[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [fluid-dev] Re : fluidsynth router for program change

From: gino latino
Subject: Re: [fluid-dev] Re : fluidsynth router for program change
Date: Tue, 24 Feb 2015 23:17:31 +0100

Tried to lauch the example script aeolus01.qmr  but no way, this is the message: "qmidiroute: cannot connect to X server "
I can't install the X server environment due to latency problems... i've installed fluidsynth on a Raspberry PI with a minimal linux installation.
I will look around for a command line tool.

Thanks again.

2015-02-24 22:16 GMT+01:00 Aere Greenway <address@hidden>:
On 02/24/2015 02:00 PM, gino latino wrote:
As i see (but i could be wrong) qmiditoute needs X server to start so i can't use it for my project... does someone know any "advanced" command line midi router?

There is a "man page" document for qmidiroute.  According to that, you can run it from the command line, as in the one I use in my desktop launcher:

qmidiroute qMidiRoute-FilterForZyn.qmr

The file name specified is the configuration, which specifies the mapping.

That being said, I don't know if it will run without the X server active.  Perhaps you could generate the configuration on a machine with X server, then use the file on a machine without it.  The file is a simple text file.

When I run it, a GUI application window appears, and it uses QT (which may require X server in order to run).


fluid-dev mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]