[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [fluid-dev] About some default values.

From: Tom M.
Subject: Re: [fluid-dev] About some default values.
Date: Thu, 17 May 2018 06:01:32 +0200

1) A gain of 1 might easily result in clipping for loud Soundfonts and
MIDIs that use many voices.

2) Not sure. It could be that the interpolation routines of
fluid_rvoice_dsp.c are not capable of upsampling (any low) sample rate
by that high factor, so one has chosen a "lower" limit of 96kHz. Ofc
you can try to hardcode a higher limit and see if it still sounds
good. And in case it doesnt, try 7th order sinc interpolation rather
than default 4th order cubic. But the question remains: Why would you
need 192kHz?


reply via email to

[Prev in Thread] Current Thread [Next in Thread]