[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Gnumed-devel] Mirth setup, versions etc was Lab importing ...

From: Dave Cramer
Subject: Re: [Gnumed-devel] Mirth setup, versions etc was Lab importing ...
Date: Fri, 1 Feb 2008 15:25:57 -0500


First attempt using hapi directly gives me the following error..

PID does not exist in the group ca.uhn.hl7v2.model.v23.message.ORU_R01

apparently there are only three elements in a ORU_R01 message. MSH, DSC, and RESPONSE.

Any pointers ?

On 31-Jan-08, at 3:21 AM, James Busser wrote:

On 23-Jan-08, at 1:49 PM, Dave Cramer wrote:

My first task is to get it from XML to HL7.

I am using Mirth 1.7 and I get an error SerializerFactory not found when trying to convert from XML to HL7

Not that the following are correct but, after hiccups I did manage to get Mirth running on Mac, so just wondered, after you selected Channels / New channel:

- in the first pane (Summary) had you set Incoming data to "XML" because, although the setting defaults to HL7 2.x which my data contains, that data is, as you already pointed out, XML-wrapped

- did your attempt to convert involve your having selected, from the Scripts tab, "Convert XML to HL7"?

I noticed when I clicked in the left navbar of the Mirth administrator "Help on this topic" I was taken to the following page

which said

If the channel receives messages pre-encoded in XML rather than ER7 then ‘Channel will receive XML pre-encoded HL7 messages’ should be checked.

but no such checkbox is apparent in 1.7... I have posted a remark to that effect in the "discussion" portion of their wiki page.

reply via email to

[Prev in Thread] Current Thread [Next in Thread]