[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [gpsd-dev] gpsd-dev Digest, Vol 94, Issue 16
|
From: |
Gary E. Miller |
|
Subject: |
Re: [gpsd-dev] gpsd-dev Digest, Vol 94, Issue 16 |
|
Date: |
Fri, 12 Jul 2019 22:55:09 -0700 |
Yo Sharmila!
On Sat, 13 Jul 2019 10:45:02 +0530
Sharmila <address@hidden> wrote:
> Can you please tell the procedure to change the CFG-NAV5 Dynmode
> using gpsd without using any tool. In my case it is set to portable
> mode.
Way easier to use ubxtool or u-center. Otherwise you have to hand
code the u-blox binary message UBX-CFG-NAV5. Then compute the
checksum, and send it to your GPS.
The easiest way is to practice with ubxtool to see it works. Then
turn up the debugging and see the exact message sent. The figure
out a way to send it to the GPS.
You can always change it on a workstation, save the config, then
use that GPS on the system without the tools.
Way more work than ust using ubxtool.
RGDS
GARY
---------------------------------------------------------------------------
Gary E. Miller Rellim 109 NW Wilmington Ave., Suite E, Bend, OR 97703
address@hidden Tel:+1 541 382 8588
Veritas liberabit vos. -- Quid est veritas?
"If you can’t measure it, you can’t improve it." - Lord Kelvin
pgpIV04HRanMb.pgp
Description: OpenPGP digital signature